Anti-Skid Marking

Anti-Skid marking

Anti-Skid marking is a tough anti-slip surface coating that works well on concrete and asphalt. It is appropriate for a wide range of surface applications such as dangerous curves, parking bays, cycleways, walkways, mini roundabouts, and before-traffic intersections. It is very durable and has an extremely strong finish that can withstand heavy traffic because of its superior anti-skid material. When applied to that specific area, it ends or reduces traffic accidents.

The primary advantage of anti-skid surfacing is that it significantly improves road safety for pedestrians and motorists. Increased friction results in shorter stopping distances at intersections and better vehicle control in bad weather.

» Anti-skid surfacing has a much longer lifespan than traditional asphalt due to its abrasion and Polish resistance.

» Another advantage of anti-skid surfacing is that We can use it on any type of road. The only requirement is that the road is in good condition before application. This means that We can even use it on bike paths.

» Because applying anti-skid marking isn’t a long, drawn-out process, the disruption to road users is usually minimal.

Technical Specifications of Anti-Skid Marking

Roadex Anti-skid system is available in two versions depending upon the client’s need:

1. Two-component resin reinforced with aggregate (Cold Applied)

2. Three component hot melt resin with aggregate (Hot Applied)

The specifications for both versions are as follows:

Resin	Methyl Acrylate or Hydro Carbon base
Aggregate	Bauxite, Carbonate of Barium or Calcium
Colors	Heat-stable Yellow, Red, White, and Blue
Packaging	25 kg two-pack system
Application Tool	Squeegee, Scatter
Touch Dry	2-4 hours at 15°C
Solvent	Not required

Method of Application

Cold Road Marking Application

1. The surface should be clean, dry, and free of foreign particles such as oil or grease.
2. Apply a smooth layer of a two-component system to the road with a squeegee and sprinkle the aggregate as needed. Smooth the aggregate with a roller until it has a uniform surface.

Warm Road Marking Application

1. The surface should be clean, dry, and free of foreign particles such as oil or grease.
2. Heat the resin, pigment, and aggregate at 150°C with constant agitation until the mixture is homogeneous. Apply the mixture to the road’s surface using a screed system at the desired thickness.